LNS QUICK LOAD SERVO S2, Startup Manual

START UP MANUAL

9

QUICK LOAD SERVO S2

Note :

For more
information
concerning
the
parameters,
see Chapter 7,
point 5.

Note :

If the previous
profile was
"Other", a text
indicating that
the loading
table needs to
be adjusted
manually will
be displayed.
See point 4.2.

3.3

Example 3 : Start-up for square bars

Specifications

Bar profile

Square

Bar diameter

40.0 mm across the flats

Length of pieces to be machined

58.0 mm

Thickness of the cutoff tool

2.0 mm

a)

Set-up of parameters :

Conditions:

The loading table is in low position 
2 bars of the new diameter are on the loading table
Bar feeder in STOP mode

Press the 

[

MENU

]

 key; the remote station displays the following text :

MAIN MENU

 
Press the numeric key 

[1]

 (Part Setup); the remote station displays the following text :

LOADING OF :   1. ROUND MATERIAL

    2. HEXAGONAL 
    3. SQUARE
    4. OTHERS

On the keypad, select 

[3]

 Square

Press the 

[ENTER]

 key twice; the remote station displays the following text:

NEW BAR STOCK DIAMETER

On the keypad enter [400]
Press the 

[ENTER]

 key twice; the motor (M2) engages and sets the loading table and the

loading fingers of the bar magazine. The remote command displays the following text :

INPUT OVERALL PART LENGTH

On the keypad, enter [600], which represents the sum of the bar length and the thickness
of the cut-off tool.

Press the 

[ENTER]

 key twice to store the data. Press the 

[ESC]

 key to exit the set-up

functions.

b)

Mechanical settings :

C

Install the 25 mm diameter pusher; see point 4.1

C

If the stock is tubing, install the special adapter; see point 4.1.2

C

Check that the table and the loading fingers are in the "Profiled bars" position; see
points 4.3 and 4.4

C

Install the optional accessories for square bars (See Instruction manual,
Appendices / Options for Quick Load Servo S2)

C

Refer to Set-up for profiled bars; see point 5.2.