10
START UP MANUAL
QUICK LOAD SERVO S2
Note :
For more
information
concerning
the
parameters,
see Chapter 7,
point 5.
3.4
Example 4 : Start-up for bars of special profile
Specifications
Bar profile
Other than round, hexagonal or square
Bar diameter
Cannot be defined (Special profile)
Length of pieces to be machined
23.0 mm
Thickness of the cutoff tool
2.0 mm
a)
Set-up of parameters :
Conditions:
The loading table is in low position
2 bars of the new diameter are on the loading table
Bar feeder in STOP mode
Press the
[MENU]
key; the remote station displays the following text :
MAIN MENU
Press the numeric key
[1]
(Part Setup); the display reads:
LOADING OF : 1. ROUND MATERIAL
2. HEXAGONAL
3. SQUARE
4. OTHERS
On the keypad, select
[4]
Other
Press the
[ENTER]
key twice.
Unlike other profiles, when "Others" is entered, no diameter needs to be entered.
The remote station displays the following text :
INPUT OVERALL PART LENGTH
On the keypad, enter [25], which represents the sum of the bar length and the thickness of
the cut-off tool.
Press the
[ENTER
]
key twice to store the data. Press the
[ESC]
key to exit the set-up
functions.
A text is displayed, indicating that the loading table will have to be adjusted in manual
mode. Follow the instructions of point 4.2 to calibrate the loading table manually.
b)
Mechanical settings :
C
Install the correct pusher adapted to the profile of the stock; see point 4.1
C
If the stock is tubing, install the special adapter; see point 4.1.2
C
Check that the table and the loading fingers are in the "Profiled bars" position; see
points 4.3 and 4.4
C
Refer to Set-up for profiled bars; see point 5.2.
Summary of Contents for QUICK LOAD SERVO S2
Page 1: ...ENG MADE IN USA ...