START UP MANUAL
3
QUICK LOAD SERVO S2
Note :
To memorize
a new
parameter or
new value,
keep
[ENTER]
pressed until
the icone
disappear.
2.
SETTINGS RELATED TO INSTALLATION
2.1
End of bar
The end of bar position determines the moment when the bar feed enters the loading
cycle.
Usually, the end of bar position is
adjusted as closely as possible behind
the clamping system of the lathe
(approximately 5 mm or a 1/4" behind
the chuck jaws or collet pads).
This will provide minimum bar stock
remnant.
Regardless of the length of the bars, or
parts, the end of bar position is always
the same.
In very special cases, a different end
of bar setting needs to be selected.
The length of the remnant may vary :
C
The minimum remnant length
(Min) is obtained when the feeding
pusher is just behind the clamping
device while the last part is being
machined.
C
The maximum remnant length
(Max) is obtained when there is not
enough material for machining an
additional part (Lp - 1 mm).
Maximum remnant length =
Lp - 1 mm + Min
End of bar setting :
Important :
Before handling the barfeeder, stop the lathe at the end of part cycle.
1.
Press the key
[STOP]
.
2.
Press the key
[MENU]
.
The display reads :
MAIN MENU
Summary of Contents for QUICK LOAD SERVO S2
Page 1: ...ENG MADE IN USA ...