LNS QUICK LOAD SERVO S2, Startup Manual

6

START UP MANUAL

QUICK LOAD SERVO S2

Functions

Conditions

By offset correction

By teaching

- Loading channel down
- No bar stock in the loading channel

Icon

 : [+/-]

Icon : 

[TEACH IN]

[+/-]

 By offset correction

C

Press the key attributed to the icon 

[+/-]

.

The display reads the current top cut position.

C

Enter the correction value with the numerical keys. Then, press the key
attributed to the icon 

[+]

 to add the value, or the  key 

[-]

 to substract it. The

display reads the new top cut position.

C

To exit the top cut set mode,  press the key attributed to the icon  

[ESC].

[TEACH IN]

By teaching

C

Press the key attributed to the icon 

[TEACH IN]

.

C

Press the key attributed to the icon 

[START]

.

The loading channel raises and loads a bar as it passes by. The feeding pusher
inserts the bar into the lathe spindle. The feeding pusher returns to its reference
position. The loading channel goes down. The feeding pusher is now facing the
spindle.

C

Press the key 

[FWD]

 and advance the bar stock to the desired position (see

previous page).

C

To validate the new top cut position, keep 

[ENTER]

 pressed until the icon

disappears

.

6. 

To exit the set mode,  press the keys 

[MENU] 

or

[STOP]

.

Note:

 If only the OFFSET function is needed, this can be accomplished by pressing [1] in

sequence 3 above, then pressing the key attributed to the icon [PAGE DOWN] until the
parameter is displayed. The "Teach In" function is not available in this menu.