LOADRITE SPRINT OPERATORS MANUAL
4
2 Quick Start Guide
This section summarises the common Loadrite procedures. For full details
of weighing methods, see Chapter 3 Weighing Overview on page 9 and
Chapter 4 Weighing Procedures on page 11
Switching On
The Loadrite powers up automatically when you switch on the ignition of the
loading machine.
If the Loadrite has been switched off for more than 30 minutes, it displays
the Warm Up screen when powered up.
Standby
The Loadrite has a ‘standby’ mode which is similar to turning the Loadrite
off.
To put the Loadrite into standby press
, the EXIT key, when in the
Ready
mode.
To restart the Loadrite, press any key.
S t an db y
The Warm Up Screen
For best weighing accuracy, the hydraulic fluid in the lift cylinders should be
at normal operating temperature. This is achieved by raising and lowering
the empty bucket or forks a few times.
The Warm up screen is displayed if the machine has been turned off over
an hour.
Raise the empty bucket or forks
past the trigger point three times.
War m u p
Lif t 3
Summary of Contents for LR911
Page 1: ...Weighing System MANUAL OPERATORS ...
Page 2: ......
Page 4: ......