LOADRITE SPRINT OPERATORS MANUAL
26
8 Error Messages
Check Power
The Loadrite has detected that the power supply has reached the unstable
level. Check that the power source is stable and b12V and +32 V.
Check Transducer
The Loadrite has detected an error in the pressure transducer signal input.
This indicates a fault in either the pressure transducer or the cable that
connects the transducer.
Check Trigger
The Loadrite has detected a fault in the trigger or the cable that connects
the trigger.
Observe safety procedures when checking the trigger.
Check Zero
The Loadrite automatically reminds the operator to check zero occasionally.
See Check Zero Prompt on page 14.
When this message appears you need to perform zero lift.
Lift Under Range
The Loadrite has detected that the Lift pressure was too low.
This indicates a fault in either the pressure transducer or the cable that
connects the transducer.
Module Data Lost
The Loadrite has an ability to store data internally in the event that the Data
Logger Module LD941 is absent or full. The Loadrite will generate this
message when the internal data storage is full and some data has been lost
as a result.
You need to install a new data module immediately to avoid further loss of
data.
Summary of Contents for LR911
Page 1: ...Weighing System MANUAL OPERATORS ...
Page 2: ......
Page 4: ......