Note
: Use These Instructions for
ULC Installations
Conduit between enclosure housing the LNI 2000 and router with
appropriate Ethernet cabling in place, may be same conduit as above.
Active POTS telephone line from alarm panel (optional, for
redundancy).
The LNI must be powered by a ULC listed burglary alarm panel or a
ULC listed UPS (Uninterruptible Power Supply).
If LNI is connected to products or components of products, which
perform communications functions only, these products or components
shall comply with the applicable requirements specified in CAN/CSA-
C22.2 No. 60950-1, Information Technology Equipment - Safety - Part
1: General Requirements. Such products include, but are not limited to:
A) hubs,
B) routers,
C) network interface devices,
D) third party communications service providers,
E) digital subscriber line (DSL) modems, and
F) cable modems.
Specifications
The table below lists the specifications for the 10-Mbps 10BaseT cable.
Parameter
RJ-45
Cable specification
Category 3 or Category 5 UTP with 22 to 24 AWG
Maximum segment length
100 m (328 ft.) for 10BaseT
Installation Options
There are several possible installation options.
These options range from a UL listed enclosure containing the alarm panel, LNI
2000, UPS, a 12V regulator such as the GE 24DC12 and router mounted on a
ULC listed mounting plate (for example, for a new installation) to each
component requiring on-site assembly (for example, for installation in an
existing building with an existing fire alarm system.)
LNI 2000 Installation Manual
11