Note
: Use These Instructions for
Standard
Installations
Step Four: Connect to Internet
The alarm system’s Internet connection must be made through a router or
combined modem/router connected to the LNI 2000.
In most cases, there will be a pre-installed router and Local Area Network
(LAN) on the customer’s premises. The presence of a network and the
availability of a router port are determined during the LNI Pre-Installation Site
Survey.
Router and Network in Place; Port Available
1.
Using the provided CAT 5 cable, plug one end’s RJ45 connector into the
LNI 2000 at the “Internet” port.
2.
Plug the other end’s RJ45 connector into a port on the customer’s router.
Note:
Do not plug into the router’s “Internet” port.
Note:
If the distance from the mounting location of the LNI 2000 to
the network router is greater than the provided CAT 5 cable (5 feet),
a longer CAT 5 cable (up to 100 feet) may be used. Note that
standard CAT 5 cable cannot be used outdoors.
Connect to Internet
3.
Verify that the LED on the “Internet” port and the IP Link LED are now lit.
LNI 2000 Installation Manual
47