TS – My Remote Control Is Not Working
Author: CT
Contributors: JR,JJ,RR
Orig. date: 9/16/10
Revised: 5/28/2015
Step 3 – Check For Faulty Remote Control
1.
Check to make sure the remote switch
on the control panel is in the “on”
position.
2.
There is a 20 second delay before the
feed wheel begins to rotate when the
machine starts up the remote is also not
usable during this time.
3.
Hold down button on transmitter for 1
second to register.
4.
Unscrew the four screws to the
control panel and pull it out and
to the side being careful not to
disconnect any additional wires.
5.
On the green electronic board
(PCB) find the connection labeled “J22”
(EL0L- EL03 models)
and ensure the
connection
from the receiver is firmly
connected.
Remote Control Switch
(EL01-EL03)
Remote Control Button
(EL04-EL05LE)
Control Panel - Open
Remote Receiver connection to
Control Panel
If the troubleshooting does not correct the issue then the
remote control is faulty and a replacement is needed.
EL20 2-Function Wireless Remote Control
E578 Key Fob
E579 Receiver
