Phone: 800.526.4041
Fax: 818.764.6061
Author: JJ Contributors: RR, CT Original Date:11/2/12 Revision: 2/17/2022
TS- I have an Over-Current or Feedback Sweep/ Elevation Error.
Trouble Shooting Instructions
circle.)
Snap in sensor on Sweep Motor (marked in Red).
Putting the Phenom Hopper Unit Case back onto
the Internal Platform Assembly.
Step 1.)
Using two people, put the Upper Hopper Unit
(A) upside-down (where the top of the hopper is resting
on the ground), and carefully flip the Internal Platform
Assembly with the Control Panel, into the bottom of the
Upper Hopper Unit. Have one person reach in threw the
control panel opening, and direct the panel until it is
hanging outside of
the Upper Hopper Unit.
Step 2.)
CAREFULLY screw in the 10 screws connecting
the Base Platform to the Hopper Unit.
(The Base
Platform Pims are very sensitive, use caution when
screwing in these screws.)
Step 2.)
Plug in the Feed Motor wire and unscrew the
ground wire (Diagram
D.
) on the control panel. Using
the 4 black screws fastening the control board to the
Phenom with Internal Platform
Assembly being placed into
Upper Hopper Unit.
Diagram
D
.)
Ground wire location. (Green)
Feed Motor location. (Red)
