Phone: 800.526.4041
Fax: 818.764.6061
Author: JJ Contributors: RR, CT Original Date:11/2/12 Revision: 2/17/2022
TS- I have an Over-Current or Feedback Sweep/ Elevation Error.
Trouble Shooting Instructions
5
Checking for Elevation Magnet.
Section 2
1.
Start by position the machine so that the
front end is facing you (the pointer.).
2.
The magnet screw ¼” is located to the left
of the pointer, (on the inner metal section of
the Davit Center.) behind the white yoke
spacer (you can see the screw threading
poking through the domed shape on the
Davit Center.). (marked in red in the
diagram below).
3.
Take your paper clip or flat-head screw
driver tip, and touch the ¼” screw thread
you located. If it attracts to the screw
bottom, then the magnet is in place.
Checking for Sweep Magnet.
4.
Using the image below, you will see the
sweep magnet marked in Green, it is located
on the back section of the platform, and the
Davit Center.
(1/4” set screw)
¼” set screw
Sweep magnet marked in Green,
Sweep Home sensor marked in
Red.
