Phone: 800.526.4041
Fax: 818.764.6061
Author: JJ Contributors: RR, CT Original Date:11/2/12 Revision: 2/17/2022
TS- I have an Over-Current or Feedback Sweep/ Elevation Error.
Trouble Shooting Instructions
Diagram D.)
Elevation Home connection red, black, and
green.
5.
Unscrew the control panel, and check the
Vien Sensor Harness connection (marked as
J10) on the circuit board. Disconnect this by
pinching on the two longer sides, and
pulling up. Blow it out and then reconnect
it.
Checking the Timing Discs
1.
Just above the Snap-In sensor, and little bit to
the right of it, there is a disc mounted on-top of
the motor. This is known as the Timing Disc.
Sometimes the motor can seize up, and the disc
can become “stuck” in place. This is generally
fixed with the help of your index finger.
2.
Use your index finger to rotate the Timing Disc
clockwise, and then counter clockwise 15 to 30
Elevation Motor (Timing Disc
highlighted in green).
