SCH Collectors Installation & Operation Manual
SCH Collectors Installation & Operation Manual
19
3
Roof Attachment Installation
(continued)
Universal cable securing kit
#SRM20012
For securing inclined collectors on tin joint roofs comprising
a guy cable, turnbuckle and hardware for collector frames
and joint clamp for guy cable tensioning. Material: stainless-
steel.
Joint clamp for cable set is required for mounting the guy
cable set on joint tin roofs with galvanized or coated sheet
steel or sheet copper (one in each guy cable set). The guy
cable set is fastened to the joint clamp.
Note:
The joint
clamp can also be used with a 1" pipe provided on site as
an additional snow guard above the collector (does not
replace the snow guard system provided on site which is a
requirement).
•
Not recommended for titanium-
zinc sheet due to danger of
cracking at low temperatures.
•
Do not reuse any stainless steel
screws as there is a risk of
breakage.
CAUTION
Install cable securing kit
1. Install the anchor bracket on the A-frame using the hex
bolt, square disk, washer, and hex nut.
2. Assemble the joint clamp as shown in FIG. 3-17 (be sure to
loosely assemble the screws on the joint clamp
assembly).
3. Place the joint clamp assembly at the appropriate
location on the joint of the tin roof.
Figure 3-17 Assemble Joint Clamp
ASSEMBLE JOINT CLAMP LOOSELY
AND PLACE ON JOINT
Figure 3-15 Kit #SRM20012 - Universal Cable Securing Kit
Components
JOINT CLAMP
PART 2 (1X)
HEX BOLT W/FLANGE (2X)
HEX BOLT (M10) (1X)
HEX NUT (M8) (2X)
WASHER (1X)
SQUARE NUT (1X)
JOINT CLAMP
PART 1 (1X)
NUT (2X)
SQUARE DISK (2X)
HEX BOLT
(M8) (2X)
WASHER
(M10) (1X)
CABLE KIT (1X)
Unpacking and checking parts
When unpacking the system, check the model names of the
components of each system and check to be sure you have the
correct number of parts (see FIG. 3-15).
Figure 3-16 Attach Cable Fastening Bracket to A-Frame
ATTACH CABLE FASTENING BRACKET
TO THE COLLECTOR
CABLE FASTENING BRACKET
INSTALLED ON COLLECTOR
