Doc. Ref.No: Q875-0143/ENG
Issue 2
Met 30+ Operating Manual
12/01/10
8. PRINTER
This document describes how a printer can be used to provide a record of the
operation of a Lock Inspections Systems MET 30+ of metal detector.
The following information is available from the printer output:
•
Product and reject counts.
•
The metal detector product settings.
•
Reject reports.
•
Metal detection sensitivity test reports.
•
Fault/incident reports.
The product and reject counts enable a record to be kept of the number of products
tested and the number of products rejected.
The product settings give the name, gain, height, width, phase and timer values for
every product that has been setup in the detector.
There is a reject report for every product in which metal is detected. This report gives
the time of the detection, the product being tested and the size and phase angle of
the signal detected.
The metal detection sensitivity test reports give a record of the time when a test
sample was passed though the detector, the PIN number of the operator who
performed the test, whether the test was successful and the size and phase angle of
the test sample.
The fault/incident reports give the time and details of any faults/incidents that have
occurred on the detector.
Two modes of operation are available, "Printing on Demand" and "Printing on
Event". Printing on demand saves all the reports in the detector, and they can be
printed at any time by either the operator or supervisor, with only the supervisor
having the authority to clear the reports. When printing on event is selected, all
reports are printed as they occur provided the printer is switched on and connected.
If this is not the case, the reports will be discarded.
Note: Met 30+ Touch Screen models can also list reports to the full screen -
See the ‘Touch Screen Display - Reports Display’ section of this manual.
File Name: Q875-0143 ENG Iss2 Met30+ Operating.doc
Page 36 of 58
