Step 6: Attach EZ Plates
Place EZ Plate A (#15) with Outside Body attached to outside of door.
Place EZ Plate B (#15) to the inside of the door making sure the
Brass Support Pin fits through the hole in the deadbolt.
Hold tight to door and secure plates together using two (2) M4 x 17mm. (#17) or M4 x 35mm. screws (#16).
3/8” to 5/8” =
INSTALLATION INSTRUCTIONS CONTINUED:
1.
Using a #2 screwdriver, remove the two (2) Red Screws.
2.
Carefully remove cover plate.
WARNING: Springs are attached to plate.
6.
Replace the cover plate and secure with two (2) Red Screws,
using a #2 screwdriver.
7.
TEST CODE before installing/re-installing lock.
3.
TURN & HOLD thumb-turn to right or left 90° to release tumblers.
IMPORTANT: THUMB-TURN MUST be turned 90°and held when
removing and inserting tumblers. Failure to do so will damage the
lock and void the warranty.
WARNING:
Do NOT force tumblers into position!
TURNING THUMBTURN 90°= CLEAR POSITION.
4.
With the thumb-turn held 90° to right or left, remove/add
CODE (Red)
and
NONCODE (Blue)
tumblers to create the desired code.
Ex: 3 Red = 3-Digit Code / 6 Red = 6-Digit Code
5.
After changing your code, release the thumb-turn to secure the
tumblers in place.
How to Change User Code/Combination
For more helpful tips and installation videos, visit
www.LOCKEYUSA.com
SAVE
Step 8: Complete Installation and Test Lock
Place Rubber Trim Plate to EZ Plate B (#15).
Place Inside Body to EZ Plate B and secure using two screws (M4 x 12mm (#7) for single combination, M4 x 25mm (#8) for DC).
Test your M210EZ Digital Door Lock before closing the door:
From Inside: Turn knob to lock, turn knob to unlock. For M210EZDC, use code to unlock.
From Outside: Turn knob to lock, use combination to unlock.
*
NOTE: If combination is needed to lock, change handing (as described in Step #3).
Locate position where Deadbolt strikes door frame and install Mortised Strike (#4).
Your installation is now complete.
2:00
8:00
10:00
4:00
Step 7: Verify Spindle Length
Insert the Spindle (#5 or #6) at the correct angle (below) into the large hole in EZ Plate B, through the deadbolt and into the Outside Body.
Spindle should extend from interior of door 3/8” min. to 5/8” max.
If the 30-45mm spindle (#6) is too long, cut it to the correct length.
*IMPORTANT: SPINDLE POSITION/ANGLE:
RIGHT-HAND DOORS: From inside, place spindle through Deadbolt, into the Outside Body (#1) in the 2:00/8:00 position.
LEFT-HAND DOORS: From inside, place spindle through Deadbolt, into the Outside Body (#1) in the 10:00/4:00 position.
*IMPORTANT:
If spindle extends less than 3/8” it may not engage the lock.
If spindle extends more than 5/8”, it will cause the lock to bind.