ENG
31
SECTION 4.7
4.7 Rain Mode
Like other digital electronic products water can trigger to activate the touchscreen and
sensor which may cause the batteries to drain. To protect the lock and extend battery life,
you can setup your Lockly Guard to enter Rain Mode to shut off keypad and fingerprint
reader whenever rain or water is detected.
Activate this feature on the LocklyPro app. While you are within the Bluetooth range or
remotely connected thru Wi-Fi hub (Secure Link), go to
Settings > Rain Mode
and toggle
the button to turn ON.
If you have not yet connected your device to LocklyPro App,
follow below steps to activate the rain mode feature:
When RAIN MODE is ON, the keypad
and fingerprint sensor cannot be used.
Unlock via LocklyPro App or physical
key. Rain Mode auto exits every 30-mins
and re-enters if water or rain is still present.
If you are using the LocklyPro app, you
will be notified when Lockly Guard entered
rain mode and it will be recorded in your
access history.
IMPORTANT
RAIN MODE ON
1. Long press to enter fixed digit keypad.
2. Enter
access code +234+
.
3. You will hear a short beep and Bluetooth
indicator flashes green once Rain Mode is ON.
RAIN MODE OFF
1. Long press to enter fixed digit keypad.
2. Enter
access code +890+
.
3. You will hear a long beep and Bluetooth
indicator flashes green once Rain Mode is OFF.
example: 234 +
example: 890 +
