23
INSTALLING THE DOORS SENSOR
Step 9
NOTE:
The arrows must be aligned or as closed as possible (less than 3/4"). If needed,
adjust the position of the sensor magnet using provided foam pads to ensure the
Lockly logo blinks red when door opens or closes.
2-3/4"
70mm
2-3/8"
60mm
Peel off the paper layer of the
adhesives from the back of the
Attach and secure with the adhesives.
Make sure you have prepared the door sensors for
installation according to Step 7
1
3
2
wired sensor
AA
.
Position the wired sensor
AA
to the edge
of the door, avoiding the door strike plate.
Close the door. Before you peel off the paper
layer of the adhesives from the sensor magnet
AB
, align the arrow with the wired sensor
AA
.
Install
AB
on to door frame.
2-
3
4
"(70mm)
2-
3
8
"(60mm)