SAFETY INSTRUCTIONS
PAIR THE REMOTE TO THE POWER STRIP
For your safety - Discard the Power strip if the plug top, supply cord or enclosure is damaged.
To reduce the risk of fire, electrical shock and/or injury, the following basic precautions should be followed:
o
This device is not intended for use by persons (including children) with reduced physical, sensory and mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instructions
concerning the use of the device by a person responsible for their safety.
o
Children should be supervised to ensure that they do not play with the devices.
o
For indoor use only. Keep away from all sources of water or moisture. Never expose the devices to the rain or
dangerous gas.
o
Do not overload. The maximum resistive load is 15Amps, 1875W.
o
Before using the product, check and make sure the electrical appliances are correctly and properly connected and
installed according to the requirements of those appliances.
o
Remove the plug top from the main outlet before cleaning. To unplug the plug top, always grasp the plug and pull
from the main outlet. Never pull the cord.
o
Do not operate any appliance with damaged cord or plug.
o
Do not try to repair, disassemble or modify the devices. There are no user-serviceable parts inside.
o
Do not use the product other than for its intended use.
o
The power strip is intended to be plugged in or connected to a 125V a.c., 60Hz and grounded power supply only.
o
Arrange the power cord away from traffic areas where it will not be tripped over.
o
The power strip may be warm during working. Keep it in a dry and cool place and do not cover.
o
Although the outlets are OFF, the power strip is powered when the main supply is connected and switched on.
1. Pressing and holding down the MODE button for more than 3 seconds in SAFE-OFF mode will put the power strip into
pairing mode.
2. The MODE indicator will flash quickly when you are in pairing mode. If there is no valid ID received within 20 seconds,
the power strip will exit from the pairing procedure and pairing will need to be re-done.
3. Pressing any button on the remote control will send its ID to the power strip and overwrite any previous ID stored.
The MODE indicator will then turn OFF and your remote will now be paired to the power strip.
o
One remote control can be paired with multiple power strips.
o
One powered strip can only be paired with one remote control.
o
The state of the MODE indicators and outlets are unchanged during pairing.
o
The stored ID will survive removal and replacement of the remote control battery and power loss to the power
strip.
o
Line of sight from the Remote Control to the power strip is not required. The control signal can pass through walls
and ceilings.
o
As with all RF transmitter devices, electrical fields, metal doors and motor devices can decrease the strength of
the transmit control signal. Reorienting the Remote Control may increase the control range.
o
It is not guaranteed that every control signal sent out by the Remote Control will be received by the power strip.
Check to make sure that the related appliances have responded after your press any button on the Remote
Control.
o
Do not press the button on the remote too rapidly.
o
If the LED indicator of the Remote Control dims, replace the battery.
Notes:
Tips for using the Remote Control:
