TIPS & SUGGESTIONS
1) Always clean the keyway thoroughly before starting.
2) After each wafer is trapped, jiggle the AccuReader key to ensure the wafer is fully seated before taking readings.
3) Use the diagram on the protective case to identify the YES line and the NO line when reading a lock.
4) Watch the demonstration video online at:
www.accureader.com
5) While holding the AccuReader key straight, keep slight upward pressure on the slide to ensure the tip is resting
along the bottom of the slide track.
6) If you get different readings on different locks, use the deepest reading for that space. This is caused when the
wafer wont fully seat due to dirt, caked grease, or is bent.
Please email us for any corrections or additions at info@accureader.com rev. 3-31-09
