28
CARE AND MAINTENANCE
BURNER REMOVAL AND CLEANING:
Before removing and cleaning burners,
ensure the following:
• All control knobs in OFF position and
griddle is completely cool.
• LP tank valve is OFF and regulator is
disconnected from tank.
• Power cord is unplugged from outlet.
NOTE:
Two people required to lift and remove
cooktop and lid from cart.
1. Rotate feet on cooktop to unlock from cart,
then lift and remove cooktop and lid.
2. Remove one screw from front of burner tent.
Lift burner tent from the front and remove
from
fi
rebox. For easier access to burners,
remove two screws from divider panel and
remove panels from
fi
rebox.
3. Remove rear hex nut from heat sensor (front
hex nut remains in place). Remove screw and
hex nut from electrode. Be careful not to bend
electrode wire tip or crack ceramic electrode
shaft.
Check burner tubes for insects and insect
nests. A clogged tube can obstruct the gas
fl
ow and can result in a
fi
re beneath the
appliance. Prevent blockages by inspecting
and cleaning burner tubes regularly.
CAUTION
When reassembling electrode, ensure a 1/8”
(3.2 mm) gap between electrode tip and burner.
Electrode tip should point directly to a burner
port hole.
Burner
1/8” (3.2 mm) Gap
Electrode
