Loctite 2265279, Operation Manual

Operating Manual  

- Page 17 - 

In Continue Mode, operator will need to setup an interval time between end of vacuum and the next 

dispense cycle. Dispenser will run as TIME

→

INTERVAL Time

→

Vacuum Time

→

Continue 

Interval Time, and then run cycle by cycle.  

1.

Press MODE Button 9, switch to CONTINUE mode. (CONTINUE indictor on) 

2.

Setup Continue time as below: 

1)

Press SET, then set interval time.  

2)

Press MODE 9 to confirm. 

Or  

1)

Press TEACH 6, TEACH indicator will flash. 

2)

press SHOT button, Finger Switch on applicator 17 or footswitch until get desired interval 

time. 

3)

Press TEACH 6, or MODE 9 to teach in interval time. 

3.

Run dispenser via press SHOT button, Finger Switch on applicator 17 or footswitch. Press 

again, cycling will be stopped. 

5.5 Shutdown 

⚫

Turn off the dispenser by Power On/Off Switch 

6  Cleaning and Changing 

Clean the roller with a dust free tissue or towel. 

Lubricate the rollers of the pump head WITH A Silicone grease once or twice a week. Lubrication 

will help prolong tube life.  

Lifetime of the Feedline: 

The PTFE tube should be replaced periodically. The lifetime of the tube will vary depending of the 

rotation speed, frequency of use, etc. The user should determine how often to replace the tube 

according to their need. 

At adjustments „Speed 5“ and „CCW“ (pump head turns right) the lifetime of the PTFE feedline 

>200 h. If the velocity will be increased the lifetime is proportionally reduced and vice versa. 

When dispensing, Cyanoacrylates apply a small amount of silicon grease to the applicator tip 

adapter 

17

 to prevent needle bonding.