Loctite 2265279, Operation Manual

Operating Manual  

- Page 16 - 

5.4.4 

Cycle Mode 

In CYCLE mode, you will need to setup interval time which is the delay between the end of 

dispense and the Vacuum suck back. .  

To setup interval time: 

1.

Press MODE Button 9, switch to CYCLE mode. (TIME indictor on) 

2.

Setup Interval time as below: 

1)

Press SET button for 2 seconds, then set interval time.  

2)

Press MODE 9 to confirm. 

Or  

1)

Press TEACH 6, TEACH indicator will flash. 

2)

press SHOT button, Finger Switch on applicator 17 or footswitch until get desired interval 

time. 

3)

Press TEACH 6, or MODE 9 to teach in interval time. 

3.

Run dispenser via press SHOT button, Finger Switch on applicator 17 or footswitch. Press 

again, cycling will be stopped. 

5.4.5 

Vacuum Mode 

Vacuum will work with TIME and Cycle. Operator will need to setup vacuum time. Dispenser will 

run as TIME

→

INTERVAL Time

→

Vacuum Time. Dispenser runs one cycle per trigger. 

1.

Press MODE Button 9, switch to VACUUM mode. (TIME indictor on) 

2.

Setup dispensing time as below: 

1)

Press SET button for 2 seconds, then set vacuum time.  

2)

Press MODE 9 to confirm. 

Or  

1)

Press TEACH 6, TEACH indicator will flash. 

2)

press SHOT button, Finger Switch on applicator 17 or footswitch until get desired vacuum 

time. 

3)

Press TEACH 6, or MODE 9 to teach in vacuum time. 

3.

Run dispenser via press SHOT button, Finger Switch on applicator 17 or footswitch. 

5.4.6 

Continue Mode