1
1
Please observe the following
1.1
Emphasized Sections
WARNING!
Refers to safety regulations and required safety measures that protect the operator or other
persons from injury or danger to life.
Caution!
Emphasizes what must be done or avoided so that the unit or other property is not damaged.
Notice:
Gives recommendations for better handling of the unit during operation or adjustment as well as
for service activities.
1.2
Items Supplied
Carefully remove the system from its shipping carton and inspect it for any signs of damage. Any
damage should be reported immediately to the carrier. Refer to the list of supplied parts below
and compare to the contents. Report any missing parts promptly to the Loctite customer service
department at 1-800-LOCTITE or 1-800-562-8483.
(1) Portable Spot Lamp Assembly
(1) UV Safety Glasses
(1) Operator Manual
1.3 For Your Safety
IMPORTANT! DO NOT OPERATE THE UNIT BEFORE READING THIS SECTION
The Loctite
®
Zeta
®
7500 Portable UV Spot Lamp is a source of long wavelength ultraviolet light
used to cure light sensitive products. The following guidelines should be followed at all times to
ensure protection from the ultraviolet light.
1. UV protective glasses with side shields should be worn when working with and around the
lamp system. Glasses should meet ANSI Z87.1 certification.
2. Potentially exposed skin should be covered. Long sleeves and protective gloves should be
worn when placing and removing parts from under the lamp.
3. Never look directly at the output from the lamp or directly into the lamp/reflector.
4. Removing the glass filter from the lamp housing may speed up the cure of some products,
however, this will also speed injury to eyes and unprotected skin. DO NOT OPERATE THE
LAMP WITH THE FILTER REMOVED.
UV safety is the responsibility of the user, especially when operating the Zeta
®
7500 in a non-
standard configuration. When in doubt about UV safety, consult a Loctite technical specialist at
1-800-LOCTITE OR 1-800-562-8483.
☞
