Connect 32 DR+ - Connect 55
User manual
116
Searching for scrambled stations
If no search for encrypted stations was performed during initial startup,
this can be done later using the search wizard.
HOME:
Call
Home
view.
Select
System settings
,
OK
call System settings.
Mark
Stations
,
go to next column.
Automatic scan TV+Radio
,
go to next column.
Select
Change search settings
,
OK
wizard guides you through the search settings.
Under
scrambled stations
you have to select
yes
.
Next select
Start search/update
,
OK
start updating the station list.
Calling CA module information
This menu is only available when a CA module is
plugged in.
HOME:
Call
Home
view.
Mark
System settings
,
OK
call System settings.
Mark
Extras
,
go to next column.
Select desired CA module.
The indicated name depends on the inserted
CA module.
go to next column.
Select
Module menu
,
OK
call information.
The content of this menu depends on the provider of
the CA module.
Smartcard rights
If two CA modules are used in parallel to decode stations, you specify
here the rights of both smartcards.
Mark
Smartcard rights
go to next column.
Select
Same rights
or
Different rights
.
If you select
Same rights
, the TV set assumes that
both smartcards have the same rights and can be used
for Dual Recording in parallel. In this case, the
Station
mapping
function is not available.
When selecting
Different rights
, you can assign the
stations to be decoded to the respective CA module.
Station mapping
If two CA modules are both used for the decoding of stations, you
decide here which station shall be decoded by which CA module.
The station mapping settings will only be taken into account, if two
CA modules are plugged.
This menu item is only available if under
Smartcard rights
the
item
Different rights
was selected.
This statement refers explicitly to the CI slots of the TV set and
not
to the modules plugged into it! When the modules are exchanged,
the mapping must be repeated.
Mark
Station Mapping
,
call station list.
Select CA module for mapping.
Mark station,
OK
map station to the selected CA module / cancel
mapping.
Behind the assigned station is the number of the
corresponding CI slot.
Storage the PIN for recordings
Store the programme provider PIN belonging to your CA module in
order to decode CI plus programmes with parental lock for recording.
The menu option is available only if the plugged CA module supports
storing the parental lock PIN.
Mark
Storage of PIN for recordings
,
call PIN entry box.
Mark the desired CA module in the headline.
Go to the PIN input line, use the numerical keys
to enter the programme provider PIN.
Or:
Mark figure,
OK
adopt figure to input line.
To conclude the entry:
Mark
Adopt
,
OK
save PIN.
Removing the CA module
Switch off TV set using the mains switch.
Remove the cover from the rear of the set.
Pull the CA module out of the CI slot.
Replace the cover.
System settings
Extras
Summary of Contents for Individual 40 Selection
