Connect 32 DR+ - Connect 55
User manual
21
Initial installation
Setting options for DVB-T reception:
If you have not selected
Terrestrial (DVB-T)
in step
Connect
antenna cable(s)
in the initial installation, proceed to the next section
Setting options for DVB-C reception
.
If several networks are available via DVB-T, you can
decide which network you want to receive your
channels from.
Select network,
OK
Confirm selection.
Proceed to next step.
Select and adapt settings for DVB-T reception.
Scrambled
stations
You can state whether coded stations are to be
searched for in the search/update.
Select
yes
to save all found scrambled stations.
However, these stations can only be received in
connection with a CA module and the appropriate
Smart Card.
The handling of the CA module is described in the
chapter
System settings
, section
Extras – CA
module
.
Search
method
If you want to run the station search independently
of the channel grid, select
Frequency search
for
the search method.
Accept
Logical
Channel
Number
In various countries, digital stations (DVB-T) are
transmitted with a preset channel number per
station, known as Logical Channel Numbers (LCN).
If you select
yes
here, these default channel slots
will be used and the channels of the preferred signal
source will be sorted as per LCN. The stations in the
station list can no longer be shifted.
Proceed to next step.
Network
selection
Please state from which network you wish to receive your station.
Note: The newly selected parameter must be confirmed with the button.
Freeview
other network
Network selection (DVB-T)
Back with Proceed with
OK
Please specify whether you want to search for scrambled stations too.
Note: Scrambled stations can only be received with an integrated CA module and
additional card.
DVB-T settings
Search method
Accept Logical Channel Number
Scrambled stations
no
yes
Channel search
Frequency search
no
yes
Back with Proceed with
Settings
Select supply voltage
no / yes
.
If you use a DVB-T antenna that requires a supply
voltage (active antenna) and which is not already
supplied via a power adaptor, then select
yes (5V)
for the antenna’s power supply.
How to align your DVB-T antenna is described in
chapter
System settings
, section
Connections
–
Antenna DVB
.
Proceed to next step.
Please state here whether your DVB-T antenna needs a supply voltage. Antennas with an
integrated amplifier need a supply voltage on the antenna line.
Supply voltage DVB-T antenna
no (0V)
yes (5V)
Back with Proceed with
Supply
voltage
Summary of Contents for Individual 40 Selection
