Connect 32 DR+ - Connect 55
User manual
26
Initial installation
Setting options for the satellite system
(DiSEqC one cable communal system):
Select
One channel
or
Two channels
.
The number of system channels can be
selected only when just one DVB-S antenna
cable is used when selecting antennas.
Here you specify if you use one or two transmission
channels in your one cable communal system.
In case of two channels - as far as they are
available in your system - different stations can
be simultaneously viewed on the main picture and
on PIP.
You get more information on your system from
your dealer.
Proceed to next step.
Select DiSEqC single cable communal
installation.
Proceed to next step.
Select satellites from list,
OK
Confirm selection.
Proceed to next step.
Number of
system
channel used
Number of system channels used
One channel
Two channels
Do you wish to use one or two transmission channels in your single cable communal
installation? With two channels - provided they are available to you from the installation - it
is possible to watch different stations at the same time in the main screen and in the PIP.
Retour avec Continuer avec
User defined
DELTA
SUM-918
KATHREIN
EXR-501
DELTA SUM-514
DELTA
SUM-928
KATHREIN
EXR-551
DELTA SUM-516
DELTA
MSU-50x
KATHREIN
EXR-552
DELTA SUM-518
DELTA
MSU-90x/170x
KATHREIN
EXR-154
Select DiSEqC single cable communal installation
Please enter here which DiSEqC single cable system you are using. The following setting
parameters of your system are then adapted accordingly.
Back with Proceed with
DiSEqC
one cable
communal
installation
Thor/Intelsat10-02 0,8
Eutelsat 5 West A 5°W
Nilesat 7°W
Eutelsat 7 West A 7,2°W
Eutelsat 8 West A 8°W
Eutelsat 12 West A 12,5°W
Telestart12 12,5°W
ASTRA3 23,5°E
ASTRA1 19,2°E
Eutelsat 16A 16°E
Hot Bird 13°E
Eurobird 9A 9°E
Eurobird 7A 7°E
ASTRA4A 4,8°E
Select satellites
Please specify here which satellite you receive.
Note: The newly selected parameter must be confirmed with the button.
Back with Proceed with
none
Optus D1160°E
Türksat 42°E
Hellas Sat2 39°E
Eutelsat 36A 36°E
Eutelsat 28A 28,5°E
ASTRA2 28,2°E
OK
Satellite
selection
.
Set LNB frequencies.
Normally, you do not need to change the
values unless the LNC (LNB) of your satellite
system uses a different oscillator frequency
(important for the frequency display).
OK
Adopt settings.
Proceed to next step.
Select and adjust settings for the DiSEqC
single cable communal installation.
OK
Adopt settings.
The manual registration must be made for both ANT
SAT jacks when either two DVB-S antenna cables or
two system channels are used.
Transmission
channel
Select the desired transmission channel.
Transmission
frequency
Select the corresponding transmission frequency.
PIN protection
If your system is designed for it, it is possible to
protect your used transmission data from use by
other subscribers with a PIN.
Define/
change PIN
Here you can determine and change the PIN for
PIN protection. Only possible, when
yes
has been
selected for PIN protection.
Proceed to next step.
Proceed to section
Setting options for DVB-S
reception (continued)
.
.
Please specify the oscillator frequency for the Low Band. High band frequency is auotm. adjusted
Note: The newly selected parameter must be confirmed with the button.
LNB frequencies
ASTRA1 19,2°E low Band 9750 MHz
10000 MHz
10200 MHz 10600 MHz
ASTRA1 19,2°E high Band
10600 MHz
10750 MHz
11000 MHz 11250 MHz
Back with Proceed with
OK
LNB
frequencies
Please log on to your DiSEqC single-cable system that is connected to the antenna input
ANT SAT and specify the desired transmission channel and associated transmission
frequency. Please also indicate whether your single-cable system has a broad frequency
band instead of a division into high and low band. If your antenna system is designed for
this, it is possible to protect your used transmission data from being used by other
participants by having a PIN.
Note: The newly selected parameter in each case must be confirmed with the button.
Transmission channel 1
2 3 4 5 6 7 8
Transmission frequency
1284 MHz
1400 MHz 1516 MHz 1632 MHz 1748 MHz
PIN protection
Ja
Nein
Define/change PIN
000
Manual registration (for socket ANT SAT)
OK
Back with Proceed with
Manual
registration
(for socket
ANT SAT)
Summary of Contents for Individual 40 Selection
