Connect 32 DR+ - Connect 55
User manual
27
Initial installation
Setting options for the satellite system (other communal
installation):
Select satellite.
OK
Confirm selection.
Proceed to next step.
Select and adapt settings.
LNC
frequency
Normally, you do not need to change the values for
high and low band, unless the LNC (LNB) of your
satellite system uses a different oscillator frequency
(important for the frequency display).
Supply
voltage
If your set is connected to a single-cable system
without external voltage supply, you can connect
the antenna supply (13V or 18V / max. 500mA).
Proceed to next step.
Proceed to section
Setting options for all types of
reception
.
Optus D1160°E
Türksat 42°E
Hellas Sat2 39°E
Eutelsat 36A 36°E
Eutelsat 28A 28,5°E
ASTRA2 28,2°E
ASTRA3 23,5°E
Eutelsat 5 West A 5°W
Nilesat 7°W
Eutelsat 7 West A 7,2°W
Eutelsat 8 West A 8°W
Eutelsat 12 West A 12,5°W
Telestart12 12,5°W
Intelsat901 18°W
ASTRA1 19,2°E
Eutelsat 16A 16°E
Hot Bird 13°E
Eurobird 9A 9°E
Eurobird 7A 7°E
ASTRA4A 4,8°E
Thor/Intelsat10-02 0,8
Select satellites
Please specify here which satellite you receive.
Note: The newly selected parameter must be confirmed with the button.
Back with Proceed with
OK
Select
single satellite
LNB frequency, supply voltage
ASTRA1 19,2°E
9750 MHz
10000 MHz 10200 MHz 10600 MHz
Supply voltage
off
13V 18V
Please specify the oscillator frequency for your LNB.
If your TV set is connected to a single cable system without an external power supply, you
can connect the antenna supply (13 or 18V/max. 350mA) with „13V“ or „18V“.
Back with Proceed with
LNB
frequencies,
Supply
voltage
Summary of Contents for Individual 40 Selection
