Connect 32 DR+ - Connect 55
User manual
89
System settings
Control
Software update via USB storage device
To do this, plug the USB stick with the downloaded software into a
free USB port of the TV set.
Calling Software update
HOME:
Call
Home
view.
Mark
System settings
,
OK
call System settings.
Mark
Control
,
go to next column.
Mark
Software
,
go to next column.
Mark
Software update
,
go to next column.
Mark
Via USB
,
call Software update.
The version of the software package that is
currently installed will be displayed.
Proceed
.
The TV set searches for a new software package
on the USB stick.
If a new software version is available after the search,
an on-screen message appears (see right hand
column).
If several different software packages are found on the
USB stick, the latest software package is always used.
If no new software package was found in the search:
BACK:
End of wizard
.
...
...
Via USB
Current software: 1.1.11.0
To load a new piece of software, you first need to search for said software on a
USB storage device that is connected (e.g. USB stick). Press the key to start
the search.
SOFTWARE UPDATE WIZARD - Current software
Proceed with
Cancel with
New software package found
Proceed
starts loading of the new software.
Or:
BACK: End of wizard
.
The update will then
not
be carried out.
Load new software package
The software is loaded in several steps. The total loading
and programming process can take up to approx. 50
minutes in total.
Please do
not
switch off your TV set with the mains
switch during the entire loading and programming
process.
After the update, the TV set is automatically powered
off and on again.
Depending on the software loaded, it is possible that
the device may not turn off automatically after the
update. Therefore, please supervise the update
process.
When the TV set is switched on again, a message is
displayed.
BACK:
End of wizard
.
...
...
Via USB
New software
Proceed with
Proceed with
End with
End with
A new software version was found.
New software: V1.1.14.0 (Current software: V.1.1.11.0)
If you now wish to load the new software, press the button. Otherwise
close with the button.
Ensure that the TV set is not switched off at the mains while it is loading the
data.
A new software version was found.
New software: V1.1.14.0 (Current software: V.1.1.11.0)
If you now wish to load the new software, press the button. Otherwise
close with the button.
Ensure that the TV set is not switched off at the mains while it is loading the
data.
60%
...
...
Via USB
Note: The loading and programming process can take up to approx. 50 minutes
in total. Please do not switch off your TV set at the mains during the loading and
programming process.
Note: Depending on the loaded software, it is possible that the device cannot
automatically switch off after the update. Therefore, please monitor the
update process.
Note: The loading and programming process can take up to approx. 50 minutes
in total. Please do not switch off your TV set at the mains during the loading and
programming process.
Note: Depending on the loaded software, it is possible that the device cannot
automatically switch off after the update. Therefore, please monitor the
update process.
Updating software
The "V1.1.14.0" software is currently being programmed, please wait ...
The software was successfully updated.
Hint
Finish wizard with
Summary of Contents for Individual 40 Selection
