8
•
The worktop veneers must be prepared with a heat-resistant adhesive (100°C) so that
they cannot detach or become deformed. The end wall profiles must be heat-resistant.
•
On one side and on the back side of a recessed glass ceramic hob there can be walls
or furniture of any height, while on the other side any piece of furniture or appliance
present must not be higher than the hob.
INSTALLATION
DIMENSIONS
MODEL
D
L
600 cm
560
490
900 cm
860
590
•
Turn the hob upside down and apply the seal supplied with the accessories kit to the
outside edge evenly.
If the appliance is installed above a cooker hood, the safety distance indicated by
the hood manufacturer must be observed. In the absence of precise indications or if
flammable materials (e.g. a shelf) are located above the appliance, the safety distance
must be at least 760mm.
If several appliances are installed under the extractor hood, for which different safety
distances are envisaged, observe the greater safety distance indicated.
•
Make the notch in the worktop according to the dimensions relative to the model (see
figure above).
•
Respect the minimum distance of 50 mm towards the rear wall and a minimum
distance of 100 mm to the right or left towards a possible side wall.
