21
Carbide Cutter OM
Maintenance
grease Points Location (Cont'd)
Use a #2 general purpose lithium based grease unless
noted otherwise.
NOTE:
Replace any broken or missing grease fittings.
Be sure to clean fittings before greasing.
8
NOTE:
Lubricate the grease point every
“
X
”
hours
indicated on the decal adjacent to the grease
point.
Numbers below after “Location” correspond to grease
point locations on opposite page.
See “Carbide Cutter Identification” on page 8 for
component location and identification.
• Rotor Bearings grease Fittings
Location: (1) Left side: Located at the left side of the
carbide cutter, at the top of the bearing guard
(2) Right side: Located at the base of the
front push bar arm. Lubricate the fitting
through the opening of the frame, (bottom
grease fitting).
NOTE:
Rotor bearings cannot be damaged by over-
greasing. Grease fittings until a small amount of
grease is purged from the bearing.
Interval: Daily or every 8 hours of operation.
• Belt Tensioner grease Fitting
Location: (3) - Located at the base of the front push bar
arm, right side. Lubricate the fitting through
the opening of the frame, (top grease fitting).
NOTE:
Remove the belt cover when lubricating the fitting.
Visually inspect the idler pulley components
while lubricating. Do Not over lubricate the idler
tensioner shaft.
NOTE:
Over lubricating may be transferred to the belt,
causing the belt to slip, resulting in loss of rotor
RPM speed and loss of power to the rotor.
Interval: Every 50 hours of operation.
Overhung Load Adapter
NOTE:
If replacing bearings or seals in the overhung
load adapter, be certain to refill with 6 oz. of
hydraulic fluid after reassembly.
Summary of Contents for 51CCH
