24
Carbide Cutter OM
Maintenance
Storage
End of Season
•
Clean entire carbide cutter thoroughly.
•
Clean belt and pulleys, relax the belt tension.
•
Lubricate all parts of the machine. See “Lubrication”
on page 20.
•
Make a list of all worn or damaged parts and replace
them.
•
Paint all parts that are worn or rusted.
•
Store carbide cutter in a clean, dry area.
•
Review the carbide cutter operator’s manual.
Beginning of the Season
•
Review the carbide cutter operator’s manual.
•
Lubricate all parts of the machine. See “Lubrication”
on page 20.
•
Tighten all bolts, nuts, and set screws. See “Torque
Specifications” on page 61.
•
Adjust belt tension. See “Belt Adjustment” on page 22.
•
Replace all damaged, worn or missing decals.
•
Install the carbide cutter on a loader and test the
carbide cutter for proper operation.
WARNINg:
DO NOT allow ANY people or
animals within 300 feet of the work area
while operating this machine
Tooth Sharpening (Quadco Option
Only) - Cont'd
NOTE:
When re-sharpening teeth using a hand grinder,
avoid overheating the tooth by lightly grinding
each tooth, moving across the entire row of teeth
before returning to the first tooth to repeat the
procedure.
NOTE:
Sharpen each tooth equally to maintain rotor
balance. Always return tooth to it’s original
location if it is removed from the rotor for
sharpening.
Can be
sharpened
to here
1"
NOTE:
Tooth can be sharpened to distance shown in
illustration above.
NOTE:
When re-sharpening teeth using a hand grinder,
avoid overheating the tooth by lightly grinding
each tooth, moving across the entire row of teeth
before returning to the first tooth to repeat the
procedure.
NOTE:
Sharpen each tooth equally to maintain rotor
balance. Always return tooth to it’s original
location if it is removed from the rotor for
sharpening.
Summary of Contents for 51CCH
