55
Carbide Cutter OM
Parts Identification
Machine Decals and Signs
NOTE:
All safety related decals are also shown in the
Safety Instructions Section along with their
location on the machine. See “Safety Decal
Locations” on page 9.
Check and replace any worn, torn, hard to read or missing
decals on your machine.
NOTE:
To order a complete Carbide Cutter Decal Kit
use part number N28473.
Part No. N17013
Part No. N20661
Part No. N17014
Part No. N16759
Part No. 4334
WARNING
Due to the possible danger of flying debris,
it is absolutely MANDATORY that impact-resistant
shielding be provided on the power unit to
protect the operator.
The owner is responsible for providing the
operator protection devices on the power unit.
WARNING
Flying Debris can gather on the skid-loader and needs to
be cleaned off, especially around the radiator and oil cooler
screens, engine compartment and exhaust areas. Periodic
cleaning will help prevent the possibility of fire.
The adjustable push bar could contact the power
unit in some positions.
Before starting the power unit, set the push bar in the
most forward position, then slowly rotate the cutter
head back while an assistant checks for clearance.
Repeat this process in the other settings to determine
which positions are usable with your power unit.
WARNING
WARNING
Rotor must be stabilized with the rotor locking pin
to prevent accidental rotation any time the rotor is
exposed for service work.
Do Not Remove the locking pin for any reason
when one or more knives are missing from the
rotor assembly. The imbalance could cause the
rotor to turn without warning, causing serious
personal injury.
Part No. N22763
Part No. N28385
Part No. N28386
Part No. 4189
WARNING
Read and understand
operator’s manual before
using this machine.
Failure to follow operating
instructions could result
in death or serious injury.
STAY BACK
KEEP HANDS AND FEET
AWAY FROM ROTATING
KNIVES UNDER MACHINE
DO NOT LEAVE
OPERATORS POSITION
WHILE POWER UNIT IS
RUNNING
DANGER
WARNING
Rotating parts hazard.
Can cause serious
injuries or death.
Do not operate machine
without shields attached.
PN 4189
WARNING
IMPROPER CONNECTION TO THE POWER UNIT’S HYDRAULIC SYSTEM
COULD CAUSE SERIOUS COMPONENT DAMAGE AND PERSONAL INJURY.
This attachment can be configured with different components to operate on a variety
of power units.
It is absolutely MANDATORY that you refer to your OPERATOR’S MANUAL for Set-up
Instructions and Pressure Ratings that apply to the components used on this unit.
The dealer/owner will be responsible for any damage caused by improper connection
to the power unit.
Summary of Contents for 51CCH
