43
Grain Bag Unloader OM
Maintenance
Lubrication (Cont’d)
Chain Lubrication
Location:
Cross Auger Extension Chain.
Interval:
Every 40 hours of operation.
Location:
Roller Drive Chain - Lubricate the chain of the
roller drive. Lubricate the top side of the chain.
Interval:
Every 40 hours of operation.
Gearbox Lubrication
WARNING:
Do not lubricate parts while
machine is running.
1
2
3
Checking Gear Lube Level of Lower Unit Gearbox
Remove the oil level plug (1) . If gear lube flows from the
hole, gear lube is at the safe operating level . Re-install
oil level plug .
L
ocation:
Bottom of Lower Unit.
Interval:
Annually.
Adding Gear Lube
Remove the oil level plug (1) and fill plug (2) . Add 80W-90
gear lube through the fill hole until it flows out the oil level
hole . Install oil level plug (1) and fill plug (2) .
Draining Gear Lube
Place a drain pan underneath the drain plug of the
gearbox .
Remove the drain plug (3) and fill plug (2) . Drain the gear
lube until the pan is empty . Reinstall the drain plug .
Remove the oil level plug (1), add 3 Qts . of 80W-90 gear
lube through the fill hole (2) until it flows out the oil level
hole (1) . Install the oil level plug (1) and fill plug (2) .
NOTE:
Dispose of engine oil, hydraulic fluid and
coolants in an environmentally safe manner.
Some regulations require that certain spills on
the ground be cleaned in a specific manner.
See local, state and federal regulations for the
correct disposal.
(Procedure continued on following page.)
Summary of Contents for GrainLogix XLB10
