14
15
CLEANING INSTRUCTIONS
SPECIFICATIONS
IMPORTANT: 80% of user difficulties can be eliminated by simply keeping the unit free of
dust and dirt at all times.
1.
Turn off the power switch and unplug the machine.
2. Clean the optical sensors:
a. You will find them near the Hopper, Counting Roller, and Stacking Tray.
b. Use the included soft brush to remove any paper particles or dust from these sensors.
c. If they require further cleaning, you may also wipe them with a soft cloth that has been
moistened with isopropyl alcohol.
3. Clean the inside:
a. Lift the Handle up, then pull back the Control Panel until it opens.
b. Use the included soft brush to remove any debris from the interior.
4. Ensure that you do not change the positions of the sensors.
Dimensions: 11.37" x 10.03" x 7.08" (289 x 255 x 180 mm)
Weight: 13.22 lbs (6 kg)
Counting Speed: > 900 pieces/minute
Power Consumption: Active ≤ 90W, Sleep Mode < 3W
Power Source: 110V ± 10V, 60 Hz
Noise: < 60 dB
Acceptable Temperature Range: 32° F – 104° F (0° C – 40° C)
Acceptable Humidity Range: 60% - 90%
Counting Range: 1 – 999
Preset Range: 1 – 100
Banknote Size Parameters: 4.33" – 7.08" long, 1.96" – 3.34" wide, 0.002" – 0.005" thick (110 – 180
mm long, 50 – 85 mm wide, 0.075 – 0.15 mm thick)
Hopper and Stacking Tray Capacity: 150 – 240 notes
To Tighten and Clean the Code Disk
Unscrew bottom screws and
remove left side panel
Tighten screw in the code disk
Clean code disk with cleaning
brush
1
2
3
