8
9
1. Antenna
2. Radiation shield &
hygro-thermo sensor
3. Mounting base
4. Battery door
5. RESET button
6. Transmission status LED
7. Bubble level
8. Rain collector
INSTALLATION INSTRUCTIONS
SETTING UP THE WIRELESS 7-IN-1 OUTDOOR SENSOR
The wireless 7-in-1 outdoor sensor measures wind speed, wind direction, rainfall, UV, light intensity,
temperature, and humidity for you.
3
WIRELESS 7-IN-1 SENSOR
4
5
6
1
2
3
7
8
10
11
9
12
1. Antenna
2. Radiation shield & Thermo-hygro sensor
3. Mounting parts (fit for 35 ~40mm diameter
pole)
4. Battery door
5.
[ RESET ]
key
6. Transmission status LED
7. Bubble level gradienter
8. Rain collector
9. Wind vane
10. UV / light sensor
11. Solar panel
12. Wind cups
9. Wind vane
10. UV/light sensor
11. Solar Cell
12. Wind cups
WIRELESS SENSOR OVERVIEW
INSTALLING THE RAIN FUNNEL
1. Align the lock grooves on the rain funnel with the lock grooves in the rain collector.
2. Lower the rain funnel onto the rain collector. Then, turn the rain funnel clockwise to lock it in place.
3
WIRELESS 7-IN-1 SENSOR
4
5
6
1
2
3
7
8
10
11
9
12
1. Antenna
2. Radiation shield & Thermo-hygro sensor
3. Mounting parts (fit for 35 ~40mm diameter
pole)
4. Battery door
5.
[ RESET ]
key
6. Transmission status LED
7. Bubble level gradienter
8. Rain collector
9. Wind vane
10. UV / light sensor
11. Solar panel
12. Wind cups
1
7
9
10
11
12
8
3
4
2
5
6
4
INSTALLATION AND SETUP
Your console can pair up with one wireless 7-in-1 outdoor sensor and up to 7 wireless indoor
sensors. (1pc wireless indoor sensor included)
INSTALL WIRELESS 7-IN-1 SENSOR
Your wireless 7-IN-1 sensor measures wind-speed, wind-direction, rainfall, UV, light intensity,
temperature and humidity for you. It’s assembled and calibrated for your easy installation.
INSTALL RAIN COLLECTOR
Rain Collector Installation
1 Align
Lock grooves
2 Lock
INSTALL BATTERIES
Unscrew the battery door at bottom of unit and insert the batteries
according to the +/- polarity indicated. Screw the battery door
compartment on tightly.
NOTE:
The red LED will begin flashing every 12 seconds.
Screw
location
3 x AA
batteries
MOUNTING POLE AND DIRECTION ALIGNMENT
Install the wireless 7-IN-1 sensor in an open
location with no obstructions above and around the
sensor for accurate rain and wind measurement.
Install the sensor with the smaller end facing the
North to properly orient the wind direction vane.
Secure the mounting stand and bracket (included)
to a 35 ~ 40mm diameter steel post or pole, and
allow minimum 2m off the ground.
Point to
SOUTH
Point to
NORTH
2 meter
off the
ground
mounting pole
and stand not
included
Add rubber
pad before
mounting on
pole or post
1
2
