3
INSTALLATION
The CR3003 cash drawer has been pre-assembled to make the
installation as simple as possible.
1. Remove the cash drawer from its shipping container.
2. Remove the keys and interface cable from its plastic bag.
3. Connect the RJ11 connector of the interface cable to the cash
drawer back panel.
4. Connect the USB connector of the interface cable to the computer
USB port.
DRIVER INSTALLATION
When hardware is installed correctly, Windows will detect the USB
cash drawer and start device driver installation. The drawer will be
installed as “HID device” automatically. Follow the instructions below
to install the virtual COM port driver in order to use COM port names
to access the cash drawer:
1. Insert the driver diskette into floppy disk drive A.
2. With Windows Explorer, select floppy drive A and double click on
the file “HidComInst.exe” to install the ”HID to virtual COM port”
conversion driver.
3. Go to "Device Manager" to check that the cash drawer has been
installed correctly under "Ports (COM & LPT)" section and note
down the assigned COM port name. To invoke “Device
Manager”, place the cursor on “My Computer” and right click, then
left click on “Properties” on the pop up menu. Then click
“Hardware” and then “Device Manager”.
4. Set up the retail POS software configuration section to use the
installed COM port number for the cash drawer.
