MATRIX ZBA7140
User’s manual
EN
Logic Group A/S
Page 24 / 31
Parameter 9, Parameter size 4. Switch Multilevel Set double-activation values for pushbutton 1.
This parameter specifies the value that are sent to the devices in the Switch Multilevel association group (group 3)
when the pushbutton is double-pressed.
Value
Description
Byte 1: Enable / Disable
0
Disabled
–
A double activation of the pushbutton will not send commands to devices in the
association group.
1
Enabled
–
A double activation will send commands to devices in the association group. Devices
will receive commands with the values set in 3 following bytes. (Default)
Byte 2: Upper switch value
0
–
99,
255
When double pressing the pushbutton for ON, a Switch Multilevel Set with this value will be send
to devices in the association group. (Default = 99)
Byte 3: Lower switch value
0 - 99
When double pressing the pushbutton for OFF, a Switch Multilevel Set with this value will be send
to devices in the association group. (Default = 0)
Byte 4: Duration
0 - 255
When double pressing the pushbutton the Switch Multilevel Set with this duration value will be
send to devices in the association group.
0
: Use dimmer default timer value. (Default)
1
–
127
: Duration in seconds.
128
–
255 : Duration in minutes (minus 127) from 1
–
128 minutes, where 128 is 1 minute.
