MATRIX ZBA7140
User’s manual
EN
Logic Group A/S
Page 10 / 31
6.4 Button functions
The pushbuttons can be configured to function in different modes with configuration parameter 7;
The standard toggle-function where the internal state is switched between on or off and between dimming up or
dimming down (Figure 3a). This is the default function of the pushbuttons.
The pushbuttons can also be configured to always switch on (key pressed) / dim up (key held), or to always switch
off (key pressed) / dim down (key held). This functionality can be used if it is required to use two pushbuttons to
control, for example, a dimmer. Then one pushbutton always dims up, and the other pushbutton always dim down
(Figure 3b).
The last function that the pushbuttons can be configured to, is to send
an “
on
” command
when the pushbutton is
held down, and when the pushbutton is released it sends an
“
off
”
command. This functionality can be used to
control devices for automatic windows or blinds, so the window is opening or closing if the button is held down,
and as soon as it is released, it stops.
Figure 3a: Toggle-function: The pushbutton can switch
on/off and dim up/down on the same button
Figure 3
b
:
Pairing function:
Here pushbutton 1
and 3 are paired where 1 always
switch
es
on
or
dims up and 3 always switches off or
dim down
.
