MATRIX ZBA7140
User’s manual
EN
Logic Group A/S
Page 15 / 31
7
Behaviour within the Z-Wave network
This product can be operated in any Z-Wave network with other Z-Wave certified devices from other
manufacturers. All non-battery-operated nodes within the network will act as repeaters regardless of vendor to
increase reliability of the network.
On delivery, the device does not belong to any Z-Wave network. The device needs to be added to an existing
wireless network to communicate with the devices of this network. Devices can also be removed from a network.
Both add and remove process are initiated by the primary controller of the Z-Wave network. This controller will be
turned into a mode for adding or removing devices. Please refer to your primary controller’s manual on how to turn
your controller into add or remove mode. Only if the primary controller is in add or remove mode, this device can
be added or removed from the network. When the device is removed from the network, it will set the device back
to factory default.
If the device already belongs to a network, follow the remove process before adding it in your network. Otherwise,
the adding of this device will fail.
7.1 Z-Wave network
– add and remove
MATRIX ZBA is a SmartStart enabled product and can be added into a Z-Wave network by scanning the Z-Wave
QR Code present on the product with a controller providing SmartStart inclusion. No further action is required and
the SmartStart product will be added automatically within 10 minutes of being switched on in the network vicinity.
Find the QR code and PIN Code on the back of the module (Figure 6a). Find the full DSK on the product
packaging.
Add MATRIX ZBA to a network with Classic Inclusion by pressing once on the switch (I) behind the pushbutton-
cover (Figure 6b). The LED near pushbutton 1 will start blinking.
Use same procedure for removing MATRIX ZBA with Classic Exclusion.
If MATRIX ZBA already belongs to a Z-Wave network, the remove process must be performed before adding it in
a new network. Otherwise, the adding of the device will fail.
(I)
(QR)
Figure 6a: SmartStart Inclusion
Figure 6b: Classic Inclusion/Exclusion
P
IN:
0
12
34
Z-WAVE DSK
