MATRIX ZBA7140
User’s manual
EN
Logic Group A/S
Page 21 / 31
10
Configuration parameters
Z-Wave products work out-of-the-box after they are added to the Z-Wave network. However, certain
configurations of a device can alter the functionality to better serve the
user’s
needs or unlock further enhanced
features.
Parameter 1, Parameter size 1 byte. Enable Central Scene notifications.
This parameter can be used for enabling or disabling Central Scene notifications.
Value
Description
0
Central Scene notifications are disabled.
1
Central Scene notifications are enabled. (Default)
Parameter 2, Parameter size 2 byte. Pushbutton press threshold time.
Specifies the time that a pushbutton must be activated before it is detected as pressed. This parameter also
affects the detection of double- and triple-activations, as a new activation must be detected within this specified
time for the repeatedly detection. Be aware that this parameter must be lower than the value in Parameter 3.
Therefore, change this parameter with caution.
Resolution is in milliseconds.
Value
Description
1
–
1000
1
–
1000 milliseconds. Default is 400 milliseconds
Parameter 3, Parameter size 2 byte. Pushbutton held threshold time.
Specifies the time that a pushbutton must have been activated before it is accepted as “held
-
down”.
This value
must be higher than the value set in Parameter 2. Resolution is milliseconds.
Value
Description
1
–
5000
1
–
5000 milliseconds. Default is 600 milliseconds.
Parameter 4, Parameter size 1 byte1. LED mode.
This parameter specifies the mode of the LED indication.
Value
Description
0
LED indication is turned off.
1
LEDs indicates the current level of the battery, when the device is included. (Default)
2
LED colour is set by configuration parameter 5.
