MATRIX ZBA7140
User’s manual
EN
Logic Group A/S
Page 6 / 31
5
Installation guidelines
5.1 Inserting Battery
MATRIX ZBA includes a battery of the type CR2032. The battery must be inserted in the battery compartment
before mounting the device. Place with the
”+” symbol upwards.
NB! Only place the battery right before the device is added to a Z-Wave network (see section about Z-Wave add
and remove processes). Otherwise the SmartStart Inclusion mode will drain the battery.
Figure 1: Inserting battery
5.2
Fastening
MATRIX ZBA is mounted in a 1 module FUGA®-compatible frame. The device can be mounted in the following
ways:
A)
In a FUGA® compatible wall box or directly on the wall with wood screws.
B)
With adhesive putty/Power tack on e.g. furniture and windows. Do not use adhesive putty on the device
itself but only on the back of the frame.
5.3 Removing the Pushbutton Cover
The pushbutton cover is removed from the device by loosening it with a slotted screwdriver in the top (A) and then
in the bottom (B). Hold the top while releasing the bottom.
(A)
(B)
