11
5.3
Alarm Time (“ALAr”)
ALARM
INIT
TIME
PM
The alarm time can be changed by pressing the
SEL
key when the display
shows “ALAr”. The existing alarm time will be shown and the alarm
indicator will be illuminated. The PM indicator will only be illuminated if
you’ve chosen the 12 hour time format and the current time is PM! For
example, if the existing alarm time is 10:30pm (12 hour format) the
display will look like this:
ALARM
INIT
TIME
PM
Change the hours by pressing the
+/HRS
key; the hours will increment
from the current setting up to 23 (or 11pm) and then “wrap-around” to 00
(or 12am). Change the minutes by pressing the
-/MIN
key; the minutes
will increment from the current setting up to 59 and then “wrap-around” to
00. If you change your mind and don’t wish to change the alarm time,
simply press the
MODE
key; the display will return to the current time
(adjusted for any fast time minutes elapsed while in this editing mode).
Once you are satisfied with the new alarm time press the
SEL
key; the
new alarm value will be in effect and stored in non-volatile memory as
well. The display will then show a DCC Accessory Decoder switch
address. If the Alarm Event Trigger is enabled (see section 5.3) then this
LNFC will send a trigger to this switch address when the alarm time is
reached. Here is an example of what the display might look like:
