19
5.6
Initial/Default Time (“Init”)
ALARM
INIT
TIME
PM
The initial (default upon power up) time can be changed by pressing the
SEL
key when the display shows “Init”. The existing initial time will be
shown and the decimal point to the lower left of the units of hours digit
will be illuminated. For example, if the existing initial time is 6:00am (12
hour format) the display will look like this:
ALARM
INIT
TIME
PM
Change the hours by pressing the
+/HRS
key; the hours will increment
from the current setting up to 23 (or 11pm) and then “wrap-around” to 00
(or 12am). Change the minutes by pressing the
-/MIN
key; the minutes
will increment from the current setting up to 59 and then “wrap-around” to
00. If you change your mind and don’t wish to change the initial time
simply press the
MODE
key; the display will return to the current time
(adjusted for any fast time minutes elapsed while in this editing mode).
Once you are satisfied with the new initial time press the
SEL
key; the
display will then show “Init” again. The new initial time will be in effect
and stored in non-volatile memory as well. At this point pressing the
MODE
key will change the display to the current time (adjusted for any
fast time minutes elapsed while in this editing mode).
