8
5. Edit
Mode
The edit mode uses the LNFC’s four front panel keys as well as the
display. The key functions are summarized as follows:
MODE:
Press this key to enter the edit mode. Press it again at any time to
return to the current time mode.
+/HRS:
Press this key to advance ahead to the next menu choice in edit
mode. When changing the fast rate, brightness, event trigger enable, or
option switch settings this key will increment the value. When entering a
time (clock, initial/default, alarm, or event start/end) pressing this key will
advance the Hours value. When entering an accessory decoder switch
address pressing this key will increase the thousands and hundreds value.
-/MIN:
Press this key to retreat back to the previous menu choice in edit
mode. When changing the fast rate, brightness, event trigger enable, or
option switch settings this key will decrement the value. When entering a
time (clock, initial/default, alarm, or event start/end) pressing this key will
advance the Minutes value. When entering an accessory decoder switch
address pressing this key will increase the tens and units value.
SEL:
Press this key to select the menu item currently displayed. When
editing parameters pressing this key will accept the change.
When you press the
MODE
key for the first time the display will change
from the current time to “cLoc”. Pressing the
+/HRS
key will move to the
next menu item; pressing the
-/MIN
key will move to the previous menu
item. Pressing the
MODE
key again at any time will return the display to
the current time. Please note that while in the edit mode the clock is still
running (if the fast rate is not 0 and the clock is not paused). The menu
items are presented in the following order:
Display
Parameter to Edit
cLoc Current
Time
rAtE Fast
Rate
ALAr Alarm
Time
Etr Event
Trigger
brit Brightness
Init Initial/Default
Time
Co X.Y
Code Revision
oPtn Option
Switch
rSt Reset
