8
6.1 – BEFORE USE CHECK THE FOLLOWING:
1. Ensure the tow ball on the vehicle is compatible with the spreader.
2. Check the operation of all controls (A).
3. Ensure the ride height is correctly set for the ATV towing the spreader (B). Remove the
fixing bolt and adjust the angle of the spreader to ensure the spreader disc is running
horizontal to the ground. Replace the fixing bolt in the nearest hole available. (The
spreader disc must run horizontally to the ground to ensure the correct spreading width
and overlap is achieved)
4. Check that the tyre pressure (C)
10psi minimum to 25psi maximum
dependant on load
size. Check the condition of the tyres. Look for signs of wear, cuts and impact damage.
5. Check the free operation for the shutter aperture (D).
6. Check the condition of the hopper and lid (E, If fitted).
7. Check that all grease points have been greased, and are operating freely.
8. Check the gearbox for oil leaks, if an oil leak is evident do not use the spreader and carry
out repairs immediately.
Check that the agitator (G) is free from debris and well greased.
9. Before filling the hopper, set the flow from the hopper by moving the pointer (A) to the
setting required (B) and locking in place with the lock nut (C).
See figure 11.1
OPERATING INSTRUCTIONS AND ADJUSTMENTS
6
