ACS-CB-SENS - MANUAL // PAGE 10
5 PRODUCT
Chapter 5.2 shows a standard model of the ACS-CB-SENS Collision Sensor, including additional products.
The exact variant of the ACS-CB-SENS is denoted by the product's order code. Consult the accompanying
data sheet to ensure that you have received the correct variant.
5.1 ABOUT INTELLIGENT SYSTEM PROTECTION
Intelligent System Protection (ISP) is LOGICDATA’s collision detection system. It aims to reduce the risk of
system damage when using LOGICDATA products. When a collision is detected, all Actuators stop immedi-
ately and move back slightly in the opposite direction (Drive Back Function). The following points must be
observed regarding the ISP function:
• ISP sensitivity and ISP shutdown values depend on the complete system (mechanical and electronic
components). Contact LOGICDATA to determine the ISP suitability of your Table System.
• If no mechanical brake is installed, ISP shutdown sensitivity will be reduced when the table is loaded.
However, if there is no load on the table top, ISP will function properly without a brake.
• After ISP is activated, the next movement of the system can only be in the opposite direction.
• ISP shutdown values can be adjusted in the system parameters. Contact LOGICDATA for further details.
5.2 KEY PRODUCT FEATURES
LOG-PRT-DMS
1
Collision Sensor
2 Cable
3 RJ10 Connector
4 DMS Cover (purchased separately)
ACS-CB-SENS
1
ACS-CB-SENS Processing Unit
2 Mounting Points
3 RJ Ports (for LOG-PRT-DMS)
4 DIN Port (for LOG-CBL-CB-SENS)
5 LOG-CBL-CB-SENS Connection cable
4
2
3
1
4
1
3
5
2
