GETTING STARTED
Logicube EchoPlus-
NG User’s Manual
8
2.1 Turning the EchoPlus-NG on and off
The EchoPlus-NG comes with a 12V grounded, 2.5A (output DC) power supply that connects to
the back of the device. Attach the included power supply to the EchoPlus-NG’s DC power port in
the back of the device.
To turn the EchoPlus-NG on, press and release the power button located on the top right corner
of the EchoPlus-NG. The EchoPlus-NG will turn on and start the boot process.
To turn EchoPlus-NG off, press and hold the power button on the top right corner of the
EchoPlus-NG until the power LED turns off.
2.2 Connecting various drive types
The SATA and USB ports on the EchoPlus-NG are hot swappable. Drives that are not being
used in any task (image, hash, wipe, etc.) can be disconnected any time. The PCIe port is not
hot-swappable.
The PCIe port is not hot-swappable. Always turn the EchoPlus-NG off when
connecting or disconnecting drives through the PCIe port.
Cables and adapters are available for the following drive types:
SATA
M.2 SATA, AHCI, and NVMe (included with the optional PCIe Kit)
mPCIe (included with the optional PCIe Kit)
2.5” and 3.5” PATA/IDE (optional)
mSATA (optional)
eSATA (optional)
Micro SATA (optional)
1.8” ZIF (optional)
1.8” PATA/IDE (optional)
Flash Media (optional)
2.2.1 Connecting Master Drives
Master drives must be connected to the left side of the EchoPlus-NG (labeled as
‘Master’ on the top-view of the EchoPlus-NG).
Never connect a master drive to the target ports of the EchoPlus-
NG. Data may be overwritten if a drive is connected to a target
port.
