Logicube EchoPlus-
NG User’s Manual
54
6: Security – Changing the default passwords
6.0 Changing the default passwords - Introduction
The EchoPlus-NG comes with default accounts created. It is highly recommended to change the
default passwords for security purposes.
logicube
it
If the new password(s) cannot be remembered, a system recovery must be
performed to reset the passwords back to the default values. Contact Logicube
Technical Support for instructions on how to perform a system recovery.
6.0.1 Changing both the
logicube
and
it
passwords
To change both the “logicube” and “it” passwords, follow these steps:
1.
Connect a USB keyboard to one of the two USB ports in front of the
EchoPlus-NG then use the following key combinations:
Alt+2
then
Alt+Shift+Enter
.
2.
Once logicube prompt appears, type the following commands, one line
at a time (Press the Enter key after each command/line):
sudo mount -o remount,rw /
passwd
3.
The following prompt will appear:
Changing password for logicube.
(current) UNIX password:
4.
Type the current password for the “logicube” account (the default
password for this account is “logicube”) then press the Enter key. The
following prompt will appear:
Enter new UNIX password:
5.
Type a new password then press the Enter key. The following prompt
will appear:
Retype new UNIX password:
6.
Type the new password again then press the Enter key. The following
response should appear:
passwd: password updated successfully
