DEFAULT PASSWORDS
Logicube EchoPlus-
NG User’s Manual
56
1.
Connect a USB keyboard to one of the two USB ports in front of the
EchoPlus-NG then use the following key combinations:
Alt+2
then
Alt+Shift+Enter
.
2.
Once logicube prompt appears, type the following commands, one line
at a time (Press the Enter key after each command/line):
sudo mount -o remount,rw /
passwd
3.
The following prompt will appear:
Changing password for logicube.
(current) UNIX password:
4.
Type the current password (by default, “logicube” without the quotes)
then press the Enter key. The following prompt will appear:
Enter new UNIX password:
5.
Type a new password then press the Enter key. The following prompt
will appear:
Retype new UNIX password:
6.
Type the new password again then press the Enter key. The following
response should appear:
passwd: password updated successfully
7.
Next, type the following command:
sudo smbpasswd logicube
8.
The following prompt will appear:
New SMB password:
9.
Type the same password you used in step 5 above. The following
prompt will appear:
Retype new SMB password:
10.
Type the same password again, then press the Enter key. The Logicube
prompt should appear.
11.
Type the following command then press the Enter key:
sudo mount -o remount,ro /
12.
Press the following key combinations to go back to the Graphical User
Interface:
Alt+1
6.0.3 Changing only the
it
password
For the username: it
