DEFAULT PASSWORDS
Logicube EchoPlus-
NG User’s Manual
57
1.
Connect a USB keyboard to one of the two USB ports in front of the
EchoPlus-NG then use the following key combinations:
Alt+2
then
Alt+Shift+Enter
.
2.
Once logicube prompt appears, type the following commands, one line
at a time (Press the Enter key after each command/line):
sudo mount -o remount,rw /
sudo passwd it
3.
The following prompt will appear:
Enter new UNIX password:
4.
Type a new password then press the Enter key. The following prompt
will appear:
Enter new UNIX password:
5.
Type the new password again then press the Enter key. The following
response should appear:
passwd: password updated successfully
6.
Next, type the following command:
sudo smbpasswd it
7.
The following prompt will appear:
New SMB password:
8.
Type the same password you used in step 5 above. The following
prompt will appear:
Retype new SMB password:
9.
Type the same password again, then press the Enter key. The Logicube
prompt should appear.
10.
Type the following command then press the Enter key:
sudo mount -o remount,ro /
11.
Press the following key combinations to go back to the Graphical User
Interface:
Alt+1
